2 prong coyote drag, 3/8 inch diameter

$6.95/dozen; $35.95/100 count

Dozen; 100 count

The CCT water drag is a heavy duty drag that's perfect for preserving set locations for mink and racoon. This drag could also be used on fox.

3" long by 1 1/4" wide; constructed with 1/8" material.

Made of 3/8 cold roll steel with a handy handle to retrieve, and a welded on nut to hammer on. All put on with a puddle weld to keep you and your driver going. Works on any style Berkshire stake.

3.5 pound--$12.50
This drag measures 7x13 with two 2/5 inch drag spikes, one on each side. The welded D ring at the top of the drag allows for fast and easy hook-up. Excellent drags for allowing a catch to leave the set area minimally undisturbed while not going far. The triangular points welded close to the vertical frame to allow snag and lockup on smaller material such as saplings.

Limit of 5 dozen per customer. Available in standard or heavy duty.

Standard: $12.95/dozen; Heavy duty: $16.50/dozen

Cast Super Stake-head only

$16.50/dozen

A heavy duty 1/2" driver used on the cast stakes. Built to last on any trap line.
**this driver is the top one in the picture

Cast Super Stake w/12" of 3/32 cable

Hammer's Trapline Products Heat Treated Driver is a 24" and made from 5/8" round stock.  It is 100% heat treated, not just the tip like others on the market.  This driver is finished with a nut and washer welded to the top for a superior striking area.

This is your standard fox grapple, and not only does it do a great job on fox, it's almost irreplaceable on the raccoon/mink/muskrat lines. I just use the heck out of these things. With most of our creeks having stone bottoms, we just chuck it out in the middle of the creek, and let it do what it does. They are not going far. I just caution you to make sure you use at least 7-8 feet of chain, and if you are dealing with a lot of grapple and chain, you are going to need machine chain. Only a backlash on a bait caster is worse than a pile of chain and 2/0 twin loop trap chain all tangled together.

$24.95 dozen

One of the strongest and longest lasting drivers on the market.  These drivers are made from 24" of 5/8" hex steel, then completely heat treated- not just the tip.

One of the strongest and longest lasting drivers on the market.  These drivers are made from 24" of 5/8" hex steel, then completely heat treated- not just the tip.

3" long by 1 1/4" wide; constructed with 1/8" material.
100 count